I2C Interface I2C Digital-output of 6 or 9-axis MotionFusion data in rotation matrix, quaternion, Euler Angle, or raw data format Input Voltage - 2.3 to 3.4 V Integrated 16 bit ADCs to enable simultaneous sampling of gyroscope & accelarometer Tri-Axis...

  Reed Switch/Sensor - Magnetic Switch - 52mm Reed Switch is a sensor that closes the circuit in presence of the magnetic field. It is a passive electronic switching component used to control the flow of electricity in a circuit....

3 Axis Sensing Supply Voltage 1.8V - 3.6V Low Power consumption 350uA (Typical) Excellent Temperature Stability Full sensing range of +/-3g. This ADXL335 Accelerometer module consists of an ADXL335 Accelerometer IC, Voltage Regulator IC, resistors, and capacitors in an integrated...

  Acceleration, Gyroscope, and Magnetometer 9 DOF module Build-in ultra-low noise linear LDO voltage regulator. Built-in onboard filters, which reduce noise from the motor and other high current electronics. All sensors are connected to the I2C bus. Build-in the Logic...

Signal output indication Single channel signal output The output effective signal is low level--Linear Magnetic Hall Effect Sensor Module and a digital interface, built-in 13 LED build a simple circuit to produce a magnetic field warning lamp comes with digital...

Supply Voltage: 3.3 V/ 5V. Interface Type: I²C, SPI. Sensing Range: ±2g, ±4g, ±8g, ±16g. Sensitivity: X: 28.6 LSB/g. Y: 31.2 LSB/g. Z: 34.5 LSB/g. Ultra Low Power: 40µA in measurement mode, 0.1µA in standby@ 2.5V. Free-Fall Detection. Tap/Double Tap Detection. -- ADXL345 Tripple Axis...

"This is Reed Switch 2 x 14 mm  Switch with Normally Open Contact.When the device is exposed to a magnetic field, the two ferrous pins inside the switch pull together and the switch closes. When the magnetic field is removed,...

  Operational Voltage: 3.3V. Ambient Light & RGB Color Sensing. Proximity Sensing. Gesture Detection. Operating Range: 4-8in (10-20cm). I2C Interface (I2C Address: 0x39). -- This is APDS9960 RGB Gesture Sensor Detection I2C Breakout Module for Arduino; a small breakout board...

3-axis Gyro+Acceleration+Magnetic Fiel Air Pressure Module Power supply: 3-5V Build in ultra low noise linear LDO voltage regulator Built-in onboard filters, which reduce noise from motor and other high current electronics You can easily select two I2C address for MPU6050...

Switch Configuration SPDT Model Name/Number GC 1625 52MM 3 PIN Current Rating 1 AMP Power/Voltage 250VAC   Reed Switch/Sensor - Magnetic Switch - 52mm 3 pin Reed Switch is a sensor that closes the circuit in presence of the magnetic...

Reed Switch/Sensor - Magnetic Switch - 28mm Reed Switch is a sensor that closes the circuit in presence of the magnetic field. It is a passive electronic switching component used to control the flow of electricity in a circuit. It...

The HMC5883L includes our state-of-the-art, high-resolution HMC118X series magneto-resistive sensors plus an ASIC containing amplification Automatic degaussing strap drivers, offset cancellation A 12-bit ADC that enables 1?to 2? compass heading accuracy The I2C serial bus allows for easy interface Measuring...

 Operation voltage: 2.2V~3.6V Operation temperature: -20°C to 60°C. No need external circuits High speed IIC protocol, speed upt to 400Khz Stand 2.54 pins, can be used directly on bread board. Digital output I2C with 400 KHz (fast mode) --   HDPM01 is...