Arduino UNO (SMD)
Rs. 999.00 Rs. 420.00
Arduino UNO (SMD)
Microcontroller ATmega328P CH340 Operating Voltage 5V Input Voltage (recommended) 7-12V Input Voltage (limit) 6-20V Digital I/O Pins 14 (of which 6 provide PWM output) PWM Digital I/O Pins 6 Analog Input Pins 6 DC Current per I/O Pin 20 mA...
Rs. 999.00 Rs. 420.00
Add to wishlist
Arduino Nano (Soldered) CH340
Rs. 490.00 Rs. 349.00
Arduino Nano (Soldered) CH340
Operating Voltage (logic level): 5V With Soldered Connector 8 analog inputs ports: A0 ~ A7 14 Digital input / output ports: TX, RX, D2 ~ D13 1 pair of TTL level serial transceiver ports RX / TX Using Atmel Atmega328P-AU...
Rs. 490.00 Rs. 349.00
Add to wishlist
Black Aluminum Heat Sink Case with Double Fans for Raspberry Pi 4 Model B
Type: Raspberry 4B Aluminum Alloy Metal Case Material: Black Aluminum Alloy Metal Compatible For Raspberry PI 4 Easy to install, Ultra-thin design. Lightweight and durable, Long-lasting stainless -- This is a must-have accessory to experience the high performance of the...
Rs. 1,100.00 Rs. 949.00
Add to wishlist
Arduino ProMini ATMEGA328P 5V/16Mhz
Microcontroller: ATmega328P Circuit Operating Voltage: 5V Clock frequency: 16MHz. 6 PWM port: D3, D5, D6, D9, D10, D11. Use For Atmel Atmega328P-AU microcontroller. Support serial download. Support 9V battery. A pair of TTL level serial port transceiver : RX /...
Rs. 999.00 Rs. 399.00
Add to wishlist
Raspberry Pi Club Power Pack 3.7V 3800mAh Lithium Battery RPI Power Pack V2.0
Battery capacity: 3800mAH Maximum discharge current: 1.8A No-load output voltage: 5.1 + 0.1V / 5.1 - 0.1V Standard charging current / voltage: 1.0A/5.0V Lithium battery saturation voltage: 4.18V-4.2V Working time: 4 hours--Battery capacity:3800mAh Maximum; Output current:1.8A, can be charged and...
Rs. 1,799.00
Add to wishlist
Camera Module OV7670 for Arduino
Operating Power: 60mW/15fpsVGAYUV. Sleeping Mode: <20 uA. Lens Size: 1/6″. Max. Frame Rate: 30fps VGA. Sensitivity: 1.3V / (Lux-sec).--OV7670 640X480 VGA CMOS CAMERA IMAGE SENSOR MODULE is a low-cost image sensor, DSP that can operate at a maximum of 30...
Rs. 350.00
Add to wishlist
Arduino MEGA 2560 R3 ATmega2560
Rs. 1,999.00 Rs. 1,850.00
Arduino MEGA 2560 R3 ATmega2560
Microcontroller: ATmega2560 EEPROM: 4KB Flash Memory: 256 KB SRAM (KB): 8 PWM Output Pins: 15 Analog I/O Pins:16 Digital I/O Pins: 54 digital input / output terminals (14 of which have programmable PWM outputs) DC Current per I/O Pin (mA):...
Rs. 1,999.00 Rs. 1,850.00
Add to wishlist
STM32 ARM Development Core Board
Rs. 1,320.00 Rs. 1,199.00
STM32 ARM Development Core Board
72MHz work frequency. 64K flash memory, 20K SRAM. 2.0-3.6V power, I/O. Reset(POR/PDR). 4-16MHz crystal. -- Board is suitable for learners that want to learn the STM32 microcontroller with ARM Cortex-M3 32-bit core.
Rs. 1,320.00 Rs. 1,199.00
Add to wishlist
Digispark Attiny85 Mini USB MCU Development Board for Arduino
High Performance, Low Power AVR® 8-Bit Microcontroller Non-volatile Program and Data Memories 512 Bytes In-System Programmable EEPROM 512 Bytes Internal SRAM USI – Universal Serial Interface (12C, SPI, 1-wire) with Start Condition Detector 10-bit ADC 4 Single Ended Channels Two...
Rs. 650.00 Rs. 449.00
Add to wishlist
Arduino MEGA 2560 CH340 SMD
Rs. 1,800.00 Rs. 1,349.00
Arduino MEGA 2560 CH340 SMD
The ATmel MCU ATMEGA16U2 MEGA 2560 R3 Improved Version CH340G Board is a micro-controller board base on the ATmega2560. It has a USB host interface to connect with Android based phones, base on the MAX3421e IC. The Arduino Mega 2560...
Rs. 1,800.00 Rs. 1,349.00
Add to wishlist
40 Pin Colorful Rainbow GPIO Female to Female Cable 20CM for Raspberry Pi
Compatible With Raspberry Pi 3 Model B+, Pi 4 Model B This 40 Pin Ribbon Cable is Specially Designed For the Raspberry Pi Model B+, Pi 4 Model B, So You can Easily Connect it to the Low-Level Peripherals.--The 40...
Rs. 250.00 Rs. 220.00
Add to wishlist
Arduino Pro Micro
Rs. 1,050.00 Rs. 979.00
Arduino Pro Micro
Microcontroller ATmega32U4 Operating Voltage 5V Input Voltage (recommended) 7-12V Input Voltage (limit) 6-20V Digital I/O Pins 20 PWM Channels 7 Analog Input Channels 12 DC Current per I/O Pin 20 mA DC Current for 3.3V Pin 50 mA--The Micro is...
Rs. 1,050.00 Rs. 979.00
Add to wishlist
Official Raspberry Pi 4 Case Red & White
Easy two-piece installation design Hole for mounting the pi inside the case Rubber pad grip at the bottom Precise access to all port and status LEDs with Symbols Raspberry LOGO on Top -- Keep your  Raspberry Pi 4 Model B...
Rs. 500.00 Rs. 339.00
Add to wishlist
ATMEL AVR USB ISP Programmer Support AT89S51 AT89S52, ATmega ATtiny Microcontrollers
Allows you to read or write the microcontroller flash, EEPROM, fuse bit and lock bits. Support for Windows, Mac OS X and Linux.SCK option to support targets with low clock speed (<1.5MHz). There is 5V supply option for target so...
Rs. 400.00 Rs. 299.00
ENC28J60 Ethernet LAN Module
Rs. 530.00 Rs. 450.00
ENC28J60 Ethernet LAN Module
ENC28J60 Ethernet chips, SOP28 package SPI Interface 1x10 connector, can be easily mounted with the MCU Built-in isolation transformer RJ45 connectors HR911105A --The ENC28J60 is a stand-alone Ethernet controller with an industry standard Serial Peripheral Interface. It is designed to serve...
Rs. 530.00 Rs. 450.00
Add to wishlist
WEMOS D1 R2 WIFI ESP8266 DEVELOPMENT BOARD
On-Board Switching Power Supply Input Voltage Range: 9V to 12V Output: 5V at 1A Max Operating Voltage: 3.3V--The D1 R2 is a WiFi capable ESP8266EX based development board in the form of the common Arduino UNO board compatible format. This...
Rs. 450.00 Rs. 399.00
Add to wishlist
ATMEL 8051 89c51 89S51 Microcontroller Development board
40 pin all leads, P0 port 10K Pull up increase host exclusion Crystal: 11.0592M Power switch and power indicator light, easy to experiment DC2.1 power seat (hole 5.5MM, 2.1MM core ) The external expansion 3 Group Expansion Power Interface Reset...
Rs. 350.00 Rs. 249.00
Add to wishlist
MCP23017 16-BIT I/O EXPANDER SERIAL I2C INTERFACE MODULE
External Reset Input Low Standby Current: 1 μA (max.) Dimension: 4cm x1cm x 1cm Weight: 10g--The MCP23017 uses two i2c pins (these can be shared with other i2c devices), and in exchange gives you 16 general purpose pins. You can...
Rs. 450.00 Rs. 399.00
USB Host Shield compatible with Arduino
Operates over the extended -40°C to +85°C temperature range Supports HID devices, such as keyboards, mice, joysticks, etc.--USB Host shield adds USB Host capabilities to the Arduino board. One is called the host (or server) and the other one is...
Rs. 1,300.00 Rs. 1,099.00
Raspberry Pi 4 Model-B with 1 GB RAM (Original New Limited Stock)
2-lane MIPI DSI display port 2-lane MIPI CSI camera port 4-pole stereo audio and composite video port H.265 (4kp60 decode), H264 (1080p60 decode, 1080p30 encode) 5V DC via USB-C connector (minimum 3A*)--Raspberry Pi 4 Model B is the latest product...
Rs. 9,999.00
Raspberry Pi 4 Model-B with 2 GB RAM (Original New, Limited Stock)
2GB/4GB Varients Quad-Core 64-bit Broadcom 2711, Cortex A72  Processor WLAN 802.11 b/g/n/ac (2,4 + 5,0 GHz) LAN RJ45 10/100/1000 Mbit (Gigabit LAN over USB 3.0) Operating Power 5V@3A  via USB Type-C Port -- Key Features: Faster processing: With one of the...
Rs. 10,999.00
Official Raspberry Pi 400 Personal Computer
  Quad-Core 64-bit Broadcom 2711, Cortex A72  Processor WLAN 802.11 b/g/n/ac (2,4 + 5,0 GHz) LAN RJ45 10/100/1000 Mbit (Gigabit LAN over USB 3.0) Operating Power 5V@3A  via USB Type-C port. Keyboard Layout: US Dual-Display Micro HDMI Ports which supports...
Rs. 13,000.00 Rs. 10,999.00
Raspberry Pi 3 Case Transparent ABS
Raspberry PI - Transparent Case For use with: Raspberry 3Color: clear Unibody, easy to install -- This is a high-Quality ABS Plastic Case for the Raspberry Pi. It is compatible with the Raspberry Pi  B+. It fully encloses the Raspberry...
Rs. 200.00 Rs. 149.00
Add to wishlist
DRV8825 CNC Shield V3
Rs. 259.00 Rs. 180.00
DRV8825 CNC Shield V3
2 x End stops for each axis (6 in total) Spindle enable and direction Coolant enable Compact design Very easy to use Latest Arduino CNC shield version V3.0 --This is an Arduino compatible V3 A4988/DRV8825 Driver CNC shield. It can...
Rs. 259.00 Rs. 180.00
Add to wishlist

Showing 1 - 24 of 113 total

You have successfully subscribed!
This email has been registered