Arduino Uno R3 DIP Development Board ATmega328P U
Microcontroller : ATmega328. Operating Voltage : 5V. Input Voltage (recommended) : 7-12V. Digital I/O Pins : 14 (of which 6 provide PWM output). Analog Input Pins : 6.   The Arduino UNO is an AVR microcontroller. It is a board-based...
Rs. 1,500.00 Rs. 649.00
Add to wishlist
Arduino Nano Board R3 with CH340 chip (without solder)
Operating Voltage (logic level): 5V 8 analog inputs ports: A0 ~ A7 14 Digital input / output ports: TX, RX, D2 ~ D13 1 pair of TTL level serial transceiver ports RX / TX Using Atmel Atmega328P-AU MCU Standard 0.1”...
Rs. 999.00 Rs. 449.00
Add to wishlist
Arduino UNO (SMD)
Rs. 999.00 Rs. 420.00
Arduino UNO (SMD)
Microcontroller ATmega328P CH340 Operating Voltage 5V Input Voltage (recommended) 7-12V Input Voltage (limit) 6-20V Digital I/O Pins 14 (of which 6 provide PWM output) PWM Digital I/O Pins 6 Analog Input Pins 6 DC Current per I/O Pin 20 mA...
Rs. 999.00 Rs. 420.00
Add to wishlist
Arduino Nano (Soldered) CH340
Rs. 490.00 Rs. 349.00
Arduino Nano (Soldered) CH340
Operating Voltage (logic level): 5V With Soldered Connector 8 analog inputs ports: A0 ~ A7 14 Digital input / output ports: TX, RX, D2 ~ D13 1 pair of TTL level serial transceiver ports RX / TX Using Atmel Atmega328P-AU...
Rs. 490.00 Rs. 349.00
Add to wishlist
Arduino ProMini ATMEGA328P 5V/16Mhz
Microcontroller: ATmega328P Circuit Operating Voltage: 5V Clock frequency: 16MHz. 6 PWM port: D3, D5, D6, D9, D10, D11. Use For Atmel Atmega328P-AU microcontroller. Support serial download. Support 9V battery. A pair of TTL level serial port transceiver : RX /...
Rs. 999.00 Rs. 399.00
Add to wishlist
Camera Module OV7670 for Arduino
Operating Power: 60mW/15fpsVGAYUV. Sleeping Mode: <20 uA. Lens Size: 1/6″. Max. Frame Rate: 30fps VGA. Sensitivity: 1.3V / (Lux-sec).--OV7670 640X480 VGA CMOS CAMERA IMAGE SENSOR MODULE is a low-cost image sensor, DSP that can operate at a maximum of 30...
Rs. 350.00
Add to wishlist
Arduino MEGA 2560 R3 ATmega2560
Rs. 1,999.00 Rs. 1,850.00
Arduino MEGA 2560 R3 ATmega2560
Microcontroller: ATmega2560 EEPROM: 4KB Flash Memory: 256 KB SRAM (KB): 8 PWM Output Pins: 15 Analog I/O Pins:16 Digital I/O Pins: 54 digital input / output terminals (14 of which have programmable PWM outputs) DC Current per I/O Pin (mA):...
Rs. 1,999.00 Rs. 1,850.00
Add to wishlist
Arduino MEGA 2560 CH340 SMD
Rs. 1,800.00 Rs. 1,349.00
Arduino MEGA 2560 CH340 SMD
The ATmel MCU ATMEGA16U2 MEGA 2560 R3 Improved Version CH340G Board is a micro-controller board base on the ATmega2560. It has a USB host interface to connect with Android based phones, base on the MAX3421e IC. The Arduino Mega 2560...
Rs. 1,800.00 Rs. 1,349.00
Add to wishlist
Arduino Pro Micro
Rs. 1,050.00 Rs. 979.00
Arduino Pro Micro
Microcontroller ATmega32U4 Operating Voltage 5V Input Voltage (recommended) 7-12V Input Voltage (limit) 6-20V Digital I/O Pins 20 PWM Channels 7 Analog Input Channels 12 DC Current per I/O Pin 20 mA DC Current for 3.3V Pin 50 mA--The Micro is...
Rs. 1,050.00 Rs. 979.00
Add to wishlist
ENC28J60 Ethernet LAN Module
Rs. 530.00 Rs. 450.00
ENC28J60 Ethernet LAN Module
ENC28J60 Ethernet chips, SOP28 package SPI Interface 1x10 connector, can be easily mounted with the MCU Built-in isolation transformer RJ45 connectors HR911105A --The ENC28J60 is a stand-alone Ethernet controller with an industry standard Serial Peripheral Interface. It is designed to serve...
Rs. 530.00 Rs. 450.00
Add to wishlist
USB Host Shield compatible with Arduino
Operates over the extended -40°C to +85°C temperature range Supports HID devices, such as keyboards, mice, joysticks, etc.--USB Host shield adds USB Host capabilities to the Arduino board. One is called the host (or server) and the other one is...
Rs. 1,300.00 Rs. 1,099.00
DRV8825 CNC Shield V3
Rs. 259.00 Rs. 180.00
DRV8825 CNC Shield V3
2 x End stops for each axis (6 in total) Spindle enable and direction Coolant enable Compact design Very easy to use Latest Arduino CNC shield version V3.0 --This is an Arduino compatible V3 A4988/DRV8825 Driver CNC shield. It can...
Rs. 259.00 Rs. 180.00
Add to wishlist
Teensy 3.2 Development Board
Rs. 2,999.00 Rs. 2,199.00
Teensy 3.2 Development Board
32 bit ARM Cortex-M4 72 MHz CPU (M4 = DSP extensions) 256K Flash Memory, 64K RAM, 2K EEPROM 21 High-Resolution Analog Inputs (13 bits usable, 16-bit hardware) 1x 12 bit DAC Analog output 34 Digital I/O Pins (16 shared with...
Rs. 2,999.00 Rs. 2,199.00
Arduino Nano Type-C V3.0 with Type-C Cable
This Arduino-compatible Nano V3.0 micro-controller is a small, complete, micro-controller board based on the ATmega328 MCU. It has more or less the same functionality as the Arduino Duemilanove, but in a smaller package. It lacks only a DC power jack,...
Rs. 950.00 Rs. 750.00
Original Arduino Mega 2560 ATmega2560 MCU Rev3
Manufacturer: Arduino Official Official Arduino Board with 3-Month brand Warranty ATmega16U2 instead 8U2 as USB to serial converter Stronger RESET circuit 5V operating voltage 40mA DC current per I/O pin 256KB flash memory of which 8KB used by bootloader 8KB...
Rs. 3,999.00 Rs. 3,300.00
Add to wishlist
MCP2515 CAN Module TJA1050 Receiver SPI 51 Single Chip Program Routine Arduino
Support CAN V2.0B technical standard, communication rate 1Mb / S. Module 5V DC power supply, SPI interface protocol control 0 to 8 bytes long data field. 8MHZ crystal oscillator 120Ω terminal resistance Use High-speed CAN transceiver TJA1050 Impedance matching, guaranteed...
Rs. 450.00 Rs. 359.00
Add to wishlist
ENC28J60 Ethernet Module 12 Pin SSOP Package
Supports Full and Half-Duplex modes Automatic Programmable Retransmit on Collision Programmable Padding and CRC Generation Automatic Rejection of Erroneous Packets SPI Interface with Clock Speeds Up to 20 MHz Chipboard ENC28J60/SS. The board 25MHZ crystal. --The ENC28J60 Ethernet Module is...
Rs. 799.00
Arduino LilyPad
Rs. 699.00 Rs. 649.00
Arduino LilyPad
Microcontroller ATmega168 or ATmega328V Operating Voltage 2.7-5.5 V Input Voltage 2.7-5.5 V Digital I/O Pins 14 PWM Channels 6 Analog Input Channels 6 DC Current per I/O Pin 40 mA Flash Memory 16 KB (of which 2 KB used by...
Rs. 699.00 Rs. 649.00
Add to wishlist
Original Arduino Uno Rev3 R3
Rs. 2,499.00 Rs. 1,899.00
Original Arduino Uno Rev3 R3
  QUICK OVERVIEW Manufacturer: Arduino Officials Micro-controller : ATmega328P. Operating Voltage: 5V. Input Voltage (recommended) : 7-12V. Digital I/O Pins: 14 (of which 6 provide PWM output). Analog Input Pins: 6. --   This Arduino Uno is an original microcontroller...
Rs. 2,499.00 Rs. 1,899.00
Add to wishlist
Adafruit Assembled Data Logging shield for Arduino
Model: Adafruit Assembled Data Logging shield SD card interface: FAT16 or FAT32 Onboard regulator: 3.3 V Real time clock (RTC) keeps the time going even when the Arduino is unplugged.   Here’s a handy Arduino shield: we’ve had a lot...
Rs. 2,850.00 Rs. 2,099.00
Add to wishlist
Data Logger module Logging Shield data Recorder Shield
SD card interface works with FAT16 or FAT32 formatted cards. 3.3v level shifter circuitry prevents damage to your SD card. Real-time clock (RTC) keeps the time going even when the Arduino is unplugged. The battery backup lasts for years. Included...
Rs. 450.00 Rs. 299.00
Add to wishlist
Expansion Adapter Breakout Board IO Shield for Arduino Nano
Compatible with Arduino NANO All digital and analog pins breakout Compact size; External power supply current support Leads all pins out, convenient for wiring and doing experiments. The Nano 328P Expansion Adapter Breakout Board IO Shield acts as a breakout board...
Rs. 280.00 Rs. 159.00
Add to wishlist
Prototype Shield V3.0 For Arduino Mega with breadboard
The shield can support being fully assembled with Arduino MEGA Support soldering components directly on this shield Support sticking the mini breadboards on this shield Reset button up top Mainboard aureate quadrate With SOP28 SMT components encapsulation   Features :...
Rs. 450.00 Rs. 249.00
Add to wishlist
BLE Nano Integrated CC2540, Bluetooth Module with Soldering
BLE chip: TICC2540 Working channel: 2.4G Interface: Micro-USB Input voltage: Micro-USB power supply, Vin6~12V, 5V Microprocessor: ATmega328P-MU QFN32 Bootloader: Latest arduino1.8.8 Pin: two rows 2.54mm-15Pin
Rs. 2,600.00 Rs. 2,099.00
Add to wishlist

Showing 1 - 24 of 63 total

You have successfully subscribed!
This email has been registered